Compartmented BESS Enclosure for an Outdoor Power System
This project involved a custom enclosure with separate battery and power conversion compartments. The system integrator specified the equipment arrangement and required independent service access to each section.
This project involved a custom enclosure with separate battery and power conversion compartments. The system integrator specified the equipment arrangement and required independent service access to each section.
Levstal fabricated the structural base, external shell and internal partition framework. Reinforcement beneath the battery racks and power conversion equipment followed the supplied load and mounting data. Each compartment received its own doors and defined cable entry areas.
The fit-out included rack supports, cable routing structures and mounting provisions for the specified cooling equipment. Penetrations through the partition were coordinated with the integrator before fabrication. Their sealing details formed part of the approved enclosure design.
Production checks focused on equipment clearances, door operation and the alignment of mounting points across the two compartments. The enclosure was shipped with its structural interfaces and agreed internal fit-out completed.
Battery technology, power conversion, fire protection and overall system validation remained within the technology suppliers’ scope.
Scope delivered: compartmented steel enclosure, reinforced equipment bases, doors, internal supports, cable routes and cooling interfaces.

